MMVARI setting „WaterFall Call - dont change frequency“ - what does it do? In advanced view window - decoded calls from rx channels and cluster digital calls are displayed at waterfall or spectrum And they are clickable.

In one cases comfortably change only tone frequency at waterfall, in other cases more comfortably change TRX frequency so that tone frequncy not changed. For example, in fsk mode.

Waterfall AGC
RX Width
UOS (for RTTY)
Display View
FFT Scale
NOISE Reduction
Waterfall Speed
Sound playback
Add CR/LF at start
Add CR/LF at end
Show CAT frequency
Show Decoded Calls
AutoSpot Calls from Channels
WaterFall Call - don't change frequency In Advanced View decoded calls from rx channels and cluster spot calls are displayed in the waterfall display. They can be clicked. Clicking a call either changes the tone frequency of the waterfall detected or it changes changes the TRX frequency so that the signal received has always the same tone frequency. This is usefull in fsk mode.
Autograb Callsign
AutoGrab Number
AutoAnswer Grabbed Calls
Automatically Answer Next
Standard View
Advanced View
Advanced Settings
mmvari_menu-mmvari.txt · Zuletzt geändert: 2021/04/02 12:28 von 2a01:4f8:192:734b::2